- Additional information
FSP-951-IV NOTIFIER, PHOTO SENSOR HEAD, IVORY – FLASH SCAN AND CLIP TECHNOLOGY.
The FSP-951-IV Notifier intelligent plug-in smoke detectors are designed for both performance and aesthetics and are direct replacements for the FSP-851 Series.
A new modern, sleek, contemporary design and enhanced optical sensing chamber are engineered to sense smoke produced by a wide range of combustion sources in accordance with more stringent code standards.
The FSP-951-IV Notifier detector sensitivity can be programmed in the control panel software. Sensitivity is continuously monitored and reported to the panel.
Point ID capability allows each detector’s address to be set with rotary, decimal address switches, providing exact detector location for selective maintenance when chamber contamination reaches an unacceptable level.
Dual electronic thermistors add 135°F (57°C) fixed temperature thermal sensing on the FSP-951T. The FSP-951R is a remote test capable detector for use with DNR Series duct detector housings.
FSP-951 series detectors are available for both FlashScan® and CLIP applications as designated.
- Two-wire SLC loop connection.
- The unit uses a base for wiring.
- Compatible with FlashScan® and CLIP protocol systems.
- Stable communication technique with noise immunity.
Each FSP-951 Series detector uses one of the panel’s addresses (total limit is panel dependent) on the NOTIFIER Signaling Line Circuit (SLC). It responds to regular polls from the control panel and reports its type and the status.
If it receives a test command from the panel (or a local magnet test), it stimulates its electronics and reports an alarm. It blinks its LEDs when polled and turns the LEDs on when commanded by the panel. The FSP-951 Series offers features and performance that represent the latest in smoke detector technology.
See all our parts for Notifier
|Dimensions||5 × 5 × 5 in|