FMM-101 NOTIFIER

$41.60

Availability: IN STOCK - READY TO SHIP SKU: FMM-101
Trust Guard Security Scanned
View cart

Description

The FMM-101 Notifier Monitor Module.

FMM-101 Notifier Mini Monitor Module

  • Built-in type identification automatically identifies this device as a monitor module to the panel.
  • Powered directly by two-wire SLC loop. No additional power required.
  • High noise (EMF/RFI) immunity.
  • Tinned stripped leads for ease of wiring.
  • Direct-dial entry of address: 01 – 159 on FlashScan loops; 01 – 99 on CLIP loops.

The FMM-101(A) Mini Monitor Module can be installed in a single-gang junction directly behind the monitored unit. Its small size and lightweight allow it to be installed without rigid mounting.

The FMM-101(A) is intended for use in intelligent, two-wire systems where the individual address of each module is selected using rotary switches.

It provides a two-wire initiating device circuit for normally-open-contact fire alarm and security devices. The FMM-101(A) can be used to replace MMX-101(A) modules in existing systems.

FMM-101 Notifier Applications

Use to monitor a single device or a zone of four-wire smoke detectors, manual fire alarm pull stations, waterflow devices, or other normally-open dry-contact devices.

It may also be used to monitor normally-open supervisory devices with a special supervisory indication at the control panel.

Monitored circuit/device is wired as an NFPA Style B (Class B) Initiating Device Circuit. A 47K Ohm End-of-Line Resistor (provided) terminates the circuit.

FMM-101 Notifier Operation

Each FMM-101(A) uses one of the available module addresses on an SLC loop. It responds to regular polls from the control panel and reports its type and the status (open/ normal/short) of its Initiating Device Circuit (IDC).

FMM-101(A) Specifications

  • Nominal operating voltage: 15 to 32 VDC.
  • Average operating current: 350 μA, 1 communication every 5 seconds, 47k EOL; 600 μA Max. (Communicating, IDC Shorted).
  • Maximum IDC wiring resistance: 1500 Ohms.
  • Maximum IDC Voltage: 11 Volts.
  • Maximum IDC Current: 450 μA. EOL resistance: 47K Ohms.
  • Temperature range: 32°F to 120°F (0°C to 49°C).
  • Humidity range: 10% to 93% noncondensing.
  • Dimensions: 1.3″ (3.302 cm) high x 2.75″ (6.985 cm) wide x 0.65″ (1.651 cm) deep.
  • Wire length: 6″ (15.24 cm) minimum.

Datasheet FMM-101.

See all our parts for Notifier.

Brand

Notifier

Additional information

Weight 0.2 lbs
Dimensions 5 × 5 × 5 in
Product Brand

Notifier

MPN

FMM-101

Product Category

1871

You've just added this product to the cart: